Menu

Hammer Categories

Get Hammer News!

We Accept:

Paypal-MasterCard-Visa-Amex-Discover

Fiberglass Handle Specs and Replacement

COMMON Nuplaglas® PROFILES

COMMON Nuplaglas® PROFILES

 

When choosing a fiberglass replacement handle, allow for a 1/8" space between the handle and eye of the hammer. The handle should not be touching the head when inserted into the eye. Measure your eye size carefully.These profiles are measured in inches

Bonding instructions for replacing a fiberglass handle can be found at the end of this page.

 Size 43

Glass Size: 43
Density: 0.0948#/ft

Stock item – IP43-11

 

 

 Size 51

Glass Size: 51
Density: 0.1356#/ft

Stock item – IP51-12

 

 

 

 Size 75

Glass Size: 75
Density: 0.2424#/ft

Stock items – IP75-13, IP75-14SG, IPE75-14SG

IP76-16, IP75-16SG, IPE75-16SG

 

 

 

 Size 85

Glass Size: 85
Density: 0.3456#/ft

Stock item – IP85-14SG

 

 

 

Size 95

Glass Size: 95
Density: 0.4104#/ft

Stock item – IP95-14SG,

IP95-16SG

 

 

 

 Size 100

Glass Size:100
Density: 0.5028#/ft

Stock item – IP10032

 

 

 

 

 Size 118

Glass Size: 118
Density: 0.6216#/ft

Stock item – IP11832

 

 

 

Size 122

Glass Size: 122
Density: 0.7356#/ft

Special order

 

 

 

 

 

 Size 139

Glass Size: 139
Density: 0.4872#/ft

Special order

 

 

 

 

 

Size 140

Glass Size: 140
Density: 0.9528#/ft

Stock item – IP14032,

IP14036

 

 

 

 

 

 Size 147

Glass Size: 147
Density: 0.6624#/ft

Special order

 

 BONDING INSTRUCTIONS USING Nuplabond®

1

Using sandpaper brisky rub the inside of the eye-hole.Remove all excess point and dirt until the walls of the eyehole are clean. Leave no residue.

2

Apply a piece of duct tape or industrial masking tape over the outside end of the head.

3

Mix part A and B of the premeasured epoxy adhesive in the tub provided or in some other small container.Pour all of the premeasured mixed epoxy into eyehole.

4

Set head with tape down on floor with open end of eyehole up.

5

Slowly place handle into epoxy until the handle stops on the floor.Hold/prop handle upright and straight for 24 hours. Use the stick to scrape any epoxy that has spilled out back into the eye.